|
|
| |
MARINE DOCK SYSTEMS
45 Wellington Street Riverstone N.S.W 2765 Australia
Ph: +61 2 9627 5577
26 Corbould Rd Coolum Beach Qld 4573 Australia
Ph: +61 7 5324 1557
 Home
Email
Enquiry Links
| |
|
BUFFER 373
Buffer Large D Section Extrusion by the metre upto 25mts per roll. For use on pontoons and marinas, UV Protected and manufactured in white extruded PVC for non marking of your boat. We hold white instock, Black is available for custom orders or check if we have instock if required.
|
|
Fitting Instructions
1. Slide the correct piece of 60 x 3 flat bar into the buffer – it’s cut 20mm short each end to make it easier to manage the corners.
2. If it’s buffer on 3 sides – start with the short side – only attempt to attach one side at a time.
3. Place the buffer (with the alloy inserted) onto the pontoon and clamp.
4. Leave the rest of the buffer atop the pontoon to prevent damage.
5. Using a 20mm hole saw bit, drill a hole into the buffer about 50mm from the edge of the pontoon and screw through the flat bar to the pontoon using the screws provided.
6. Space the holes approx. 300mm apart and continue drilling the holes and screwing the buffer on as you go.
7. When you get to the corner, slide the next piece of 60 x 3 flat bar into the buffer and stop 20mm short from corner.
TIP: Using the hole saw bit, drill a hole on the back side of the buffer so you see when the flat bar is in the correct position
8. Cut a small V in the top of the buffer and bend the buffer around the corner. Clamp in a few places again.
9. Drill the first hole on this side about 50mm from the corner and continue with approx. 300mm spacings.
10. Repeat the corner procedure again and then finish with the final side of the buffer, trim it to the right length before fixing last screw.
11. Use Gumption to clean the buffer
|
|
|
| |
MARINE DOCK SYSTEMS
45 Wellington Street Riverstone N.S.W 2765 Australia
Ph: +61 2 9627 5577
26 Corbould Rd Coolum Beach Qld 4573 Australia
Ph: +61 7 5324 1557
Home
Email
Enquiry Links
| |
|
|
MDS Logo 1981
